Neon Signs

Neon signs are luminous-tube signs that contain neon or other inert gases at a low pressure. Applying a high voltage (usually a few thousand volts) makes the gas glow brightly. They are produced by the craft of bending glass tubing into shapes. more...

Home
Bath
Bedding
Furniture
Gardening & Plants
Home Decor
Lamps, Lighting, Ceiling...
Bathroom Lighting
Ceiling Fans
Ceiling Fixtures
Chandeliers
Children's Lighting
Desk Lamps
Exterior, Landscape Lighting
Floor Lamps
Lava Lamps, Party Lights
Lighting Accessories
Multiple Lamp Sets
Neon Signs
Night Lights
Other Lamps, Lighting
Paper Lanterns
Pendant Lighting
Picture Lights
Recessed Lighting
Sconces, Wall Lamps
String Lights
Table Lamps
Track Lighting
Under Cabinet Lighting
Patio & Grilling
Pools & Spas
Rugs & Carpets

A worker skilled in this craft is known as a glass bender, neon or tube bender.

History

The neon sign is an evolution of the earlier Geissler tube (also called a Crookes tube), which is a glass tube for demonstrating the principles of electrical discharge. Neon signs are used for many purposes.

At the 1893 World's Fair, the World Columbian Exposition in Chicago, Illinois, Nikola Tesla's neon lamp signs were displayed. The development of neon signs is credited to Georges Claude and the first public display of a neon sign was of two 38-foot long tubes in December of 1910 at the Paris Expo. The first commercial sign was sold by Jaques Fonseque, Claude’s associate, in 1912 to a Paris barber.

Manufacturing process

Lead glass tubing in external diameters ranging from about 8 to 15 mm is most commonly used. The tube is heated in sections using several types of burners that are selected according to the amount of glass to be heated for each bend. These burners include ribbon, cannon, or crossfires, as well as a variety of torches that run on a simple combination of natural gas (butane or propane work better, however natural gas is cheapest) and air.

A section of the glass is heated until it is malleable; then it is bent into shape and aligned to a pattern containing the graphics or lettering that the final product will ultimately conform to.

An electrode is melted (or welded) to each end of the tube as it is finished. The electrodes are also lead glass and contain a small metal shell with two wires protruding through the glass to which the sign wiring will later be attached. All welds and seals must be perfectly leak-proof before proceeding further.

The tube is attached to a manifold which is itself attached to a high-quality vacuum pump. The tube is then evacuated of air until it reaches near-vacuum. During evacuation, a high current is forced through the tube via the wires protruding from each electrode (in a process known as "bombarding"). The current depends on the specific electrodes used and the diameter of the tube, but is typically in the 500mA to 1000mA range, at an applied voltage usually between 15,000 to 25,000V. The bombarding transformer acts as an adjustable constant current source, and the voltage produced depends on the length and pressure of the tube. Typically the operator will maintain the pressure as high as the bombarder will allow to ensure maximum power dissipation and heating. This very high power dissipation in the tube heats the glass to a temperature of several hundred degrees Celsius, and any dirt and impurities within are drawn off in the gasified form by the vacuum pump. The current also heats the electrode metal to over 600 degrees Celsius, which activates a special coating that scavenges unwanted contaminants in the tube and reduces the work function of the electrode for cathodic emission. When completed properly, this process results in a very clean interior at a high vacuum.

Read more at Wikipedia.org